NSSHKCGEOEU SCHRÄM–TENAX®–VE
Cable for cutting machine Schräm-TENAX®-VE according to DIN VDE 0250, Part 812
Technical data: 
NSSHKCGEOEU SCHRÄM–TENAX®–VE
CONSTRUCTION
1. Flexible tinned copper conductor in special flexible construction
2. Coloured core insulation of heat resistant rubber compound of type 3GI3, based on EPR, with particularly high mechanical strength. Cores wrapped with rubberized textile tape. Cores are twisted around a centre saddled separator.
3. Inner sheath of semi-conducting rubber compound
4. Outer sheath of chlorinated rubber compound of type 5GM5, abrasion, tear and oil resistant, selfextinguishing
A. Working core
B. Earth conductor – distributed as strands of very thin copper wire around insulation of signalling core and as a flexible conductor of tinned copper located in saddled separator
C. Signalling core – cores with copper-steel conductors, capable of dilating, insulation of type 3GI3 compound (based on EPR). The signalling cores are located in outer interstices of twisted cores
Application
For connection of mobile machines with very high mechanical load, especially in mines, e.g. for coal cutting machines. Suited in particular for extreme bending stressing with low tensile stress.The cable meets requirements given in test standards DIN VDE 0472, Part 818 “Behaviour under clamping stress”. It secures that a damage produced by clamping is detected as an earth fault with maximum possible probability.
TECHNICAL SPECIFICATION
Rated voltage U0/U: 0.6/1 kV
Bending radius:
- fixed installation min. 1.5 x D
- flexing min. 2.5 x D
Temperature range:
- fixed installation min. -40 °C max. +80 °C
- flexing min. -25 °C max. +80 °C
Colour of sheath: yellow